Altair Inspire Form Manufacturing Feasibility

Course Summary

Inspire Form makes it possible to improve sheet product design and the manufacturing process, while reducing lead time for sheet metal parts by enabling early consideration of form-ability, process parameters, material utilization, and cost. This is an introductory class for sheet metal forming simulation utilizing Inspire Form and is intended for design engineers, manufacturing process engineers, and CAE analysts.

Prerequisites:

None

Session 1 (10 AM - 1 PM)

Introduction to Forming Analysis
Inspire Form Overview
Inspire Form Feasibility Model Setup
Feasibility Results visualization
Blank fit and Blank Nesting Analysis

Session 2 (2 PM – 5 PM)

Inspire Form Tryout
Tryout Results visualization
Multistage process setup
Springback Analysis process setup
Springback Results visualization and Die Compensation

Inspire Form Manufacturing Feasibility

Upcoming events

No results

Past events

Showing all previous events – show less

Language	Delivery Method	Event status	Seats available	Session times	Rooms	Session status
English	In Person	Over	9	April 9, 2024, 12:30 AM - 7:30 AMTimezone: America/Detroit	Altair Delhi Office	Session over
English		Over	9	December 11, 2023, 11:30 PM - December 12, 2023, 6:30 AMTimezone: America/Detroit	Altair Delhi Office	Session over
English		Over	9	November 20, 2023, 11:30 PM - November 21, 2023, 6:30 AMTimezone: America/Detroit	Altair Delhi Office	Session over
English		Over	9	October 11, 2023, 12:30 AM - 7:30 AMTimezone: America/Detroit	Altair Delhi Office	Session over
English	In Person	Cancelled	8	March 19, 2024, 12:30 AM - 7:30 AMTimezone: America/Detroit	Altair Delhi Office	Cancelled
English		Cancelled	9	February 13, 2024, 10:00 AM - 5:00 PMTimezone: Asia/Kolkata	Altair Delhi Office	Cancelled

Inspire Form Manufacturing Feasibility

Course Summary

Inspire Form Manufacturing Feasibility

Upcoming events

Past events

Welcome again

Please note if you wish to receive a certificate of course completion or resume the course where you stopped before, you must log into the Learning Management System before you start the course.