This class is part of a five-class series but can also stand by its own.

These are the classes being part of that series:

• HyperWorks Pre - Interface
• HyperWorks Pre - Geometry Cleanup and Midsurfacing
• HyperWorks Pre - 2D Meshing and Direct Midmeshing
• HyperWorks Pre - 3D Meshing and 1D Meshing
• HyperWorks Pre - Model Setup OptiStruct and Connectors

Prerequisites:

It is recommended to have attended the HyperWorks Pre - Interface class beforehand.

Goals and Objectives:

• Connection of parts through connectors and contacts
• Material, property creation and assignment
• Creation of boundary conditions and forces
• Creation of load cases
• Definition of outputs
• Check the model