Embed – Introduction to Embedded Development using the Arduino Uno
This session is part of a five-class series but can also stand by its own.
These are the sessions being part of that series:
- Session 1: Embed - Getting Started
- Session 2: Embed - Introduction to Embedded Development using the Arduino Uno
- Session 3: Embed - State Charts
- Session 4: Embed - Advanced Features
- Session 5: Embed - Firmware Development using the Texas Instruments F28069M
Prerequisites:
It is recommended to have attended the Embed – Getting Started session beforehand.
Goals and Objectives:
- Arduino Uno Hardware Description
- Terminology and code generation
- Standalone and Interactive Hardware In the Loop (HIL)
- LED blink examples
- Fixed Point Library
- Compound Blocks – Conditional Execution
- Target Interface Block – CPU Utilization
- Reading a Potentiometer
- Creating a Potentiometer Controlled Servo Motor
Upcoming events
No results